New CC cup holders

New finishes for my interlocking CC Cup Holders, rust , shimmer and multiple colours are available. check the link for my ETSY store.

 

AMFX Creations CC Cup Holder on ETSY

Golden Supreme Oven Temperature test

Oven heating up

Golden Supreme oven temperature test

The following test was performed with a standard oven thermometer, the oven was set to level 1 and left for half an hour to heat up then after 15 minutes it was turned up to the next level and left for another 15 minutes. The following temperature where recorded. However my thermometer maxed out so could not accurately measure levels above 8.

1 = ± 70°c

2 =  ±110°c

3 =  ±140°c

4 =  ±200°c

5 =  ±240°c

6 =  ±310°c

7 =  ±350°c

8 =  ±400°c

9 and 10 are above  ±410°c 

 

Telesis Adhesive tack time comparison

Below are the times I recorded during multiple tests using PPI Telesis adhesive.

Old Telesis 5 = 4-5 sec before tack

New Telesis 5 = 5-6 sec tack

Telesis 8 = 20-25sec tack

Telesis 8F = 8-10 sec tack

Australian Airbrush Review: Paasche airbrush colour cup caps

Australian Airbrush Review: Paasche airbrush colour cup caps: Just finished a new batch of Paasche colour cup lids. Up on Etsy and through my Ecwid store on the right of the page. Amfx Creations Etsy ...

Australian Airbrush Review: Airbrush Protective Nozzle

Australian Airbrush Review: Airbrush Protective Nozzle: Old Thayer & Chadlers and Badger brushes came with protective caps to protect the expensive needle and prevent damage to the tip. I fo...

Airbrush Protective Nozzle

Old Thayer & Chandlers and Badger brushes came with protective caps to protect the expensive needle and prevent damage to the tip. I found these rubber caps for my brushes. Pushes onto most airbrushes including Iwata, Badger and Sparmax. Due to the nature of the material it will stretch to fit a wide variety of nozzles.

 Airbrush pictured is a Thayer & Chandler Vega. Will not fit single action Paasche H style brushes.

Dimensions
A = 9mm
B = 22mm

Available here at my Ecwid store

or 

Available on Etsy here

Paasche airbrush colour cup caps

Just finished a new batch of Paasche colour cup lids. Up on Etsy and through my Ecwid store on the right of the page. Amfx Creations Etsy Store

Back to the Future Marty Mcfly boomerang pins are back in stock.

Marty Mcfly Boomerang pin https://www.etsy.com/au/listing/218847337/back-to-the-future-marty-boomerang-pin